Antique Radio Speaker/Grille Cloth, Small Star, 18” x 24", Shipping incl. in US

$24.00 Buy It Now 4d 10h, FREE Shipping, eBay Money Back Guarantee

Seller: richmonddesignsinc (3,508) 99.5%, Location: Greenwood, Louisiana, Ships to: Worldwide, Item: 183963330258 This design, representing a small four point star, was used by many manufacturers,... in the 1930s. Atwater Kent, Emerson and some of the West Coast radio manufacturers, such as Jackson Bell, Falck, Etc. Star size is one eighth of an inch. NOTE Larger sizes are available here on Ebay, just email me with your measurements and I will send you an offer Please be sure to click on See other items, just below our ebay name in the top right corner of the listing.Thank you,Richmond Designs Inc Small Star A True 1930s Pattern Design Duplication 18" X 24" Payment is with Paypal Only Shipping is included in the continental US. Grille Cloth Installation Instructions First,...mist the cloth lightly with a water mist, ......spraying lightly , not heavy. You want the cloth to be damp during the application process. This allows the cloth to shrink as it dries stretching any wrinkles that may be left.. Next roll your pattern face in, just as I sent it to you,...then make sure your pattern is aligned straight with the edge of your board across the top ( or bottom), then roll it out and check the side for alignment. Do this before applying the spray adhesive. If you are not applying the cloth to a speaker board, but directly to the cabinet, you will obviously want to roll the cloth the opposite way. A speaker board is recommended. Then, using 3M Super 27 or 77 spray adhesive, apply it to the edge of the board and all around the outer edge about a one inch wide band on the face side.You do not want to spray glue all over the board. Leave the inner field area of the board clean, free of any adhesive.This leaves the cloth free to stretch as it dries. (You can also spray the glue on a piece of paper and use a brush for applying in tight places.)Let the glue dry for about 15 minutes. Do not spray adhesive anywhere on the cloth. On a clean area of your work space, roll the cloth from the bottom up to the top, rolling your face side inward. Start the application in one corner at the top checking your design to be straight across. Then roll it out top to bottom. Make sure your first edge at the top is straight and secure. Then as you stretch the cloth gently, watch your pattern design , keeping it straight , so not to over stretch the design. Tightening slightly , top to bottom,... then side to side. Once you have achieved the desired position, fold the outer excess cloth down over the glued edge of your board. Let the project sit about one hour, then after the cloth has completely dried you may finish the trimming the back edge., if needed. This site is the only place to buy authentic vintage radio grille cloth duplications, After many years of hard work and persistence, we finally found a weaver to work with us right here in the USA. From the first run off the looms to this date, we have managed to offer several authentic patterns. Our patterns were set up years ago and they are here to stay. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Our 1930s duplications are sold all over the world. Thank you for viewing,Richmond Designs Inc Condition: New, Country/Region of Manufacture: United States

PicClick Insights PicClick Exclusive
  •  Popularity - 314 views, 12.1 views per day, 26 days on eBay. Super high amount of views. 11 sold, 7 available.
  •  Price -
  •  Seller - 3,508+ items sold. 0.5% negative feedback. Great seller with very good positive feedback and over 50 ratings.
Similar Items