Seller: top-ledlamp✉️(917)99.6%,
Location:CA / KY, United States, US,
Ships to: US,
Item:126201104973For Ford Five Hundred 2005-2007 Combo LED Headlight Hi Low & Fog light bulbs Kit. Car LED headlight color temperature are balancing. Fog Light Bulbs Specifications LED headlight has a simple structure, and the parts are less than the xenon lamp, which is lower than the xenon lamp failure rate!
LED headlight advantages:
Voltage: DC9~32V
Power: 80W
Light flux: 6000LM
Chip Type: Efficient COB
Material: Aluminum 6063
Color temperature: 6000K
Protection level: IP68
Stable work: -40~+140°C
Usage: car headlights (high / low beam)
LED lamps are more energy and power than conventional halogen lamps.
The brightness is close to the xenon lamp, but the LED lights are illuminated without delay to enhance road safety.
Instantly start without strong current impact, improve battery life by more than 30%.
Fast cooling , using the most advanced, heat-dissipating structural design.
The power driver adopts a wide voltage constant current mode which has a simple structure, so that the automobile can flexibly cope with various voltage unstable conditions, and has achieved the purpose of less component damage. Compared to HID ballast maintenance, The repair probability is very low which is less than 80%.
Low heating temperature, The working temperature of helium can reach 800°-1000°
LED headlight has a simple structure, and the parts are less than the xenon lamp, which is lower than the xenon lamp failure rate!
Car LED headlight color temperature are balancing. Xenon bulbs are clear in the same color, about 6000K.
Fog Light Bulbs Specifications:
Bulb Size: H10/9145
Color: 6000K White
LED Quantiy: 10pcs Per Bulb
LED Type: SMD High Power Chip
Beam Type: 360° Beam Angle
Operating Voltage: DC 9V ~ 32V , Fit for 12V & 24V vehicle.
High Power: 40W per bulb
Luminous Flux: 4000LM per set
Material: Aaluminum profile and virtually unbreakable PMMA Lens
Long-lasting Lifespan 30000 Hours
Plug and Play Easy Installation
Fast on/off Response Time and Vibration Resistant
Install Caution:
As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
Put the vehicle into park or make sure it is securely in gear.
Be sure to turn off the ignition and remove the key.
Be careful to avoid burns, especially when turning on or off the vehicles lighting.
Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.