This is an acylic for the SunQuest Pro 24R Tanning Bed
This bed has 24 lamps
This is for the bottom acrylic
It is a curved acrylic
It measures 72 x 30 1/2 inches ( make sure of measurements)
Free Shipping in the continental US
We can ship to Canada for a little extra fee
If this is not what you're looking for please contact me
Established in 1991 our acrylic manufacturer remains the leader
In technology and sales of tanning bed acrylics.
We have over 2,500 tanning bed acrylics available
Our Quality...
Established over 18 years agoour acrylic manufacturer
Remains the leader in the manufacturing of high quality tanning bed acrylics.
They use only the highest grade of acrylic sheet available, thus assuring excellent UV transmission and longevity.
They continuously test our finished acrylics for UV transmission, durability and workmanship to insure each acrylic is of the highest caliper and worthy All acrylics are re-inspected prior to shipment to assure quality, workmanship and fit.
Frequently Asked Questions about tanning acrylics
Q.
What should I clean my acrylic with.
A.
Only a acrylic cleaner formulated especially for tanning acrylics should be used. Household cleaners do not have the germ or bacteria killing strength to sanitize your bed. Most household cleaners are often irritating to the skin.
Q.
What can I use to clean off finger nail polish.
A.
You can use lighter fluid or another acetone type solvent to clean the polish off. Immediately wash the area with bed cleaner to remove all the solvent. If solvent residue remains on the surface, the acrylic may craze.
Q.
How often should I replace my acrylics?
A.
Both acrylics should be replaced every 1500 hours (2 bulb changes). Although an acrylic may look clear after 1500 hours the transmission rate of the acrylic has dropped considerable. Why put new bulbs in a bed if the full effect doesn't reach the customer?
Q.
What causes crazing in the bends?
A.
Excessive heat or excessive age usually causes crazing inside of the bends.
Q.
What causes surface crazing?
A.
Surface crazing usually is a result of a non- indoor tanning lotions being used or an improper bed cleaning solution. Since acrylic is a petroleum based product any products containing oils will craze the surface.
Q.
Why did my acrylic break or crack?
A.
The Major reasons are:
1. Due to exposure to the radiation an acrylic only has a life span of about 1500 hours (2 bulb changes). Excessively high UVB strength of modern lamps also accelerates the acrylic premature failure.
2. The bed has been overheating due to cooling fans out or installed incorrectly
3. Excessive weight on the acrylic. Most beds will adequately support most people. However some beds lack an adequate support system for the acrylic. Extra supports can be purchased if an acrylic breakage problem continues.
Q.
What is Annealing?
A.
Annealing is the process of reheating an acrylic to its molding point and then cooling back down. This relieves the stress caused in forming.
Q.
Can I repair a cracked acrylic?
A.
Broken acrylics can not be successfully repaired.
Internet Warning: Bewareof sites selling cheaply made tanning bed acrylics, with limited warranties. Many of these sites use untested foreign made acrylic.
Know your Seller! Do they have their name and address on their site? Do you really know who they are?
The seller establishes the cost of shipping and cost of shipping insurance, regardless of what any buyer-selected shipping service might charge the seller.
Returns Accepted
Must be returned in new/unused condition, and in original packaging. Buyer is responsible for return shipping (and shipping both ways for an exchange), and shipping insurance. You must contact us first
