Fitment:
2007-2009 Honda CR-V 2.4L
Radiator Features:
-OE design to ensure exact fit, form and function for an easy drop-in installation;
-Built with high density multi-lowered fins for maximum cooling efficiency;
-ISO 9001 certified manufacturing plants;
-Direct Replacement;
-Improve Cooling Efficiency;
-100% Leak Tested;
-Plastic tanks with aluminum core;
-Built to strict quality control standards;
AC Condenser Features:
-Aluminum construction to ensure heat transfer efficiency
-Louvered aluminum fins and tubes are bonded through a unique furnace-brazing process with premium quality aluminum for maximum heat dissipation
-Each product is quality inspected and 100% tested
-Lightweight Direct Bolt-On OEM Fitment or Replacement
-Guaranteed Exact Fit for easy installation
How to clean radiator:
1. Start the vehicle, to rise to normal temperature. Slowly open the tank cover, the fluid shake from the tank after filling the mouth, the cleaner can be mixed with any brand of coolant. Idle running not less than 15 minutes, not cleaning vehicles not less than 30 minutes for two years. And then discharge coolant, flush water tank, until out of clear water, suitable for any water cycle system.
2. After cleaning, after waiting for pipeline rehabilitation add fluid to water tank, and inject new coolant and water purification.
How to replace the radiator:
1. Disconnect the battery.
2. Drain the radiator fluid into a suitable container.
3. Remove the old radiator:
-Take off any plastic covers around the radiator.
-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.
-Disconnect the radiator hoses from the radiator.
-Disconnect the transmission cooling lines from the bottom of the radiator.
-Remove any clamps, brackets, or screws holding the radiator inside its frame.
-Lift the radiator up and out of the car.
4. Install the new radiator:
-Slide the new radiator into place.
-Connect any clamps or brackets that hold the radiator in place.
-Connect the transmission cooling lines carefully.
-Connect the engine cooling hoses to the radiator.
-Replace the fan and fan shroud.
-Reconnect the fan electrical connection.
-Replace the plastic covers.
5. Fill the radiator with fluid.
6. Check your work to make sure that there are no leaks.
(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)
Note: Do please keep children and pets away when replacing the radiator)
Note:
1. Project operation, the vehicle normal temperature 60 to 80 degrees.
2. Add detergent if the tank is too full can take some antifreeze.
Know about the AC Condenser:
AC Condenser: The condenser is part of the A/C system. It receives the hot, high-pressure gaseous refrigerant from the compressor and cools it to a warm liquid state, although still under high pressure.
Location: The Condenser is located right in front of the radiator. High pressure (hot) refrigerant travels through it and cools off as air passes through. Most late-model condensers cannot be flushed due to multiple flow paths, and must be replaced if restricted.
Check: If testing proves that your condenser is leaking, restricted, or otherwise damaged, don’t pay the high dealer price for a replacement, when you can get an OE quality condenser for much less from Replace.
Package:
1pcs of brand new radiator&1pcs of brand new ac condenser
Item Specifics | |
---|---|
Brand | vap-autoparts |
Manufacturer Part Number | IC818374L |
Warranty | 2 Year |
Other Part Number | RAD13031,Replacement Radiator Condenser cooling kit |
Custom Bundle | Yes |
Modified Item | No |
Fitment Type | Direct Replacement |
Placement on Vehicle | Front |
Type | Radiator & Condenser |
Radiator Material | Aluminum |
Condenser Material | Aluminum |
Radiator Tank Material | Plastic |
Quantity | Radiator*1 |
Height | 15-3/4 In. |
Width | 28-11/16 In. |
Thickness | 5/8 In. |
Weight | 24lbs |
Radiator Cap | As picture shows |
Notes | Radiator & Condenser will be shipped out separately |
You have 7 days to contact us and 10 days to return it from the date it was received. If this item is inyour possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
Store Cat. Store Home
key
Ignition Coil
Towing Mirrors
Oxygen Sensor
Wheel Hub Bearing
wheel Lug Nuts
Window Regulator
Lift Supports
Window Switch
Fuel Pump
Throttle Body
Thermostats & Parts
Fuel injector
Radiator Coolant Tank
CV Axle Assemblies
windshield wiper motor
Blend Door Actuator
Door Handle
Wheel Spacers
Transfer Case Shift Motor
Secondary Air Injection Pump
Running Board Motor
oil pan
harmonic balancer
Center Console Organizer Parts
ATV Brake Caliper
Suspension Kits ◈ suspension wen jie ◈ suspension cj ◈ suspension okx ◈ suspension fu ◈ Suspension Kits
Rear wheel axle
coilover
ATV Brake Master Cylinder
complete strut
headlight motorcycle
Foot Rest Pedal
O-Ring
Mass Air Flow Sensor
CV Axle
CDI BOX
Crankcase Vent Valve
Jeep 9
Splash Guards & Mud Flaps
Cylinder Piston Kit
Brake System ◈ Brake Disc Rotors ◈ Brake Pads ◈ Brake Disc Rotors and Pads ◈ Brake Caliper ◈ Brake Pads & Rotor & Caliper ◈ Brake Pads & Calipers
horns
snorkel air intake
Removal Open Tools
Dipstick
Shocks & Struts
Light Bar Mount Bracket
Glow Plugs
Tire Pressure Sensor
Dash Cover
Sun Visor
roof rack
window visor
bug shield
Bumper
Tonneau Cover
Spoiler Wing
Fender flares
Body Kits
Cylinder Head Gasket Sets
Crankshaft Pulley
Spindle
Timing Belt Kits
4 Pcs wheel hub bearing
Steering Knuckle
UTV & ATV Brake System Parts ▷ Brake Pads ♢ Sintered Brake Pads ♢ Kevlar Carbon Brake Pads ◈ Brake Shoes
leveling lift kit
ATV Tires
Brake hose
Turbocharger
Rocker Arm
vehicle speed sensor
ABS speed sensor
Knock sensor
Camshaft & Crankshaft
Strut Mount
Hub Caps
ATV Ignition Switch
fog lights
Brake Pad Sensor
Rear View Camera
Cold Air Intake
Jack Stand
Pivot Brake Clutch Lever
Fuse Holder Box
Pillar Posts
Windshield Outer Trim
Cooling System ◈ Radiators ◈ A/C Condensers ◈ Cooling Fans and Fan Clutches ◈ Intercoolers ◈ Radiator Support ◈ Radiator Hose
Brake Rotors Pads & Drum Shoe
Air Conditioning ◈ Evaporator ◈ Heater Core ◈ Accumulator/Drier ◈ Blower Motor Fan
Air Suspension
alternator
AC Compresoor
cargo cover
Intake Manifold
Intake House
Rear Window Louver Cover
Engine Splash Shield ◈ Catalytic Converter Protection ◈ Engine Splash Shield Guard
C Notch & Flip Kit
Other Golf Cart Parts
Primary Drive Clutch
winch
Headlight Assembly
Tensioner
Steering Wheel
Submersible Water Pump
Body Side Door Moulding
A-Arms
Motorcycle Carburetor & Parts
Fuel Valves &Petcocks
Variable Timing Solenoid(VVT)
Car Tools
RV Water Pump
Cylinder piston gasket kit ◈ Cylinder piston gasket kit
Jeep Wrangler
Wheel Hub Bearing Knuckle
Purge Valve
Power Brake Booster
timing chain kit
sensor-8
Wheel Rim
Lights ◈ Side/Cab Marker Lights ◈ Instrument Panel Lights ◈ Third Brake Lights ◈ Interior Lights ◈ Exterior Lights ◈ Led Headlight ◈ Special Model Lights
Parking Sensor
Starter
power steering rack
driveshaft
flywheel
Air suspension valve solenoid
Suspension+Strut+Bearing
Regulator Rectifier
Ignition Coil & Spark Plug Set
steering knuckle-7
Ballast Module
Engine Motor
Oil Catch Can
Shift Knob Lever Head
Botorcyle Exhaust Pipe
Household Air Cooler
Air Dryer
Bushing
Tilt Trim Motor
Steering Shaft
Bed Step
CV Axle Boot
Wheel Hub Centric Rings
Other New List Item
|
Aluminium Radiator & AC Condenser Cooling For 2007 2008 2009 Honda CR-V 2.4L L4
Fitment: 2007-2009 Honda CR-V 2.4L
Radiator Features: -OE design to ensure exact fit, form and function for an easy drop-in installation; -Built with high density multi-lowered fins for maximum cooling efficiency; -ISO 9001 certified manufacturing plants; -Direct Replacement; -Improve Cooling Efficiency; -100% Leak Tested; -Plastic tanks with aluminum core; -Built to strict quality control standards;
AC Condenser Features: -Aluminum construction to ensure heat transfer efficiency -Louvered aluminum fins and tubes are bonded through a unique furnace-brazing process with premium quality aluminum for maximum heat dissipation -Each product is quality inspected and 100% tested -Lightweight Direct Bolt-On OEM Fitment or Replacement -Guaranteed Exact Fit for easy installation
How to clean radiator: 1. Start the vehicle, to rise to normal temperature. Slowly open the tank cover, the fluid shake from the tank after filling the mouth, the cleaner can be mixed with any brand of coolant. Idle running not less than 15 minutes, not cleaning vehicles not less than 30 minutes for two years. And then discharge coolant, flush water tank, until out of clear water, suitable for any water cycle system. 2. After cleaning, after waiting for pipeline rehabilitation add fluid to water tank, and inject new coolant and water purification.
How to replace the radiator: 1. Disconnect the battery. 2. Drain the radiator fluid into a suitable container. 3. Remove the old radiator: -Take off any plastic covers around the radiator. -Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly. -Disconnect the radiator hoses from the radiator. -Disconnect the transmission cooling lines from the bottom of the radiator. -Remove any clamps, brackets, or screws holding the radiator inside its frame. -Lift the radiator up and out of the car. 4. Install the new radiator: -Slide the new radiator into place. -Connect any clamps or brackets that hold the radiator in place. -Connect the transmission cooling lines carefully. -Connect the engine cooling hoses to the radiator. -Replace the fan and fan shroud. -Reconnect the fan electrical connection. -Replace the plastic covers. 5. Fill the radiator with fluid. 6. Check your work to make sure that there are no leaks. (Tools need to be prepared: Screwdrivers, Wrenches, Drain pan) Note: Do please keep children and pets away when replacing the radiator)
Note: 1. Project operation, the vehicle normal temperature 60 to 80 degrees. 2. Add detergent if the tank is too full can take some antifreeze.
Know about the AC Condenser: AC Condenser: The condenser is part of the A/C system. It receives the hot, high-pressure gaseous refrigerant from the compressor and cools it to a warm liquid state, although still under high pressure. Location: The Condenser is located right in front of the radiator. High pressure (hot) refrigerant travels through it and cools off as air passes through. Most late-model condensers cannot be flushed due to multiple flow paths, and must be replaced if restricted. Check: If testing proves that your condenser is leaking, restricted, or otherwise damaged, don’t pay the high dealer price for a replacement, when you can get an OE quality condenser for much less from Replace.
Package: 1pcs of brand new radiator&1pcs of brand new ac condenser
You have 7 days to contact us and 10 days to return it from the date it was received. If this item is inyour possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
Copyright of ignition-coil. All rights reserved. |