Ok, I've got a 1928-1931 ford truck rat rod project. There is no title because I havent gotten that far. The cab, frame, and bed were built by a Heath at New Metal Kustoms in Kentucky. The motor is a 1950's ford 223ci straight six along with a matching three speed trans from the same vehicle that the motor is from. I personally have dissassembled and fully checked the internals. The internals of the motor have been magnafluxed and all is great with the motor. I do not have a yoke for the trans but do have a drive shaft to fit the crown vic rear end. The front axle is from a 1930 ford model a, front brakes are from a 1955 ford f100 with new bearings and seals. The spindles are from a 1938 ford truck. I have split the wish bones and welded in new bungs and threaded heim joints. The split wish bones are from a 1938 ford truck. The motor mounts are made by myself and are tacked in quite well. There is no trans mount made yet. Transmission shift into all gears with the new Mr. Gasket three speed shifter. I have two steering wheels and shafts that go with the truck. One is from the same 1938 ford truck, and the other is from a Jeep that I found in the junk yard. I also have the dash from the old jeep that's been cut down. Speedo guage is still in the dash from the jeep. It gives that vintage feel having the large speedo. There is a front grill from a 1929 ford that I was going to use to hold the radiator and also goes with the truck. The rear end is from a crown vic and the emergency cables are still attached. The truck has no interior.The wheels and tires are original to a 50's merc and are 16x4 with a 3.5 inch white wall. Ive got two vega steering boxes to go with the project. I've got bolts holding on the front axle but it will need the correct perches to be installed. The cab is a slant roof with speed holes cut in the visor. Mini Bear Claw latches are installed for the doors to lock shut. The gas tank is an spun aluminum 15 galon tank that is mounted in the rear of the truck. I wish that I had time to finish but that isnt the case. If you have questions or requests for additional pic's just let me know.